Description

The 15mm ” End Feed Bent Tap Connector joins 15mm copper tube to a ” BSP tap or valve tail with a built-in 90 bend. The soldered capillary end takes the copper tube and the swivel union nut with fibre washer seals the tail without jointing compound the bend brings a 15mm supply up neatly to bath taps and appliance tails in tight spots. Manufactured from copper to BS EN 1254-1 and fits copper tube to BS EN 1057.

Also known as: bent tap connector, angled tap connector, tap tail connector, bent tap coupling, swivel bent tap connector, inch bent tap connector, 15mm bent tap connector, endfeed bent tap connector.

• Manufactured to BS EN 1254-1 for capillary (solder) fittings
• Connects 15mm tube to a ” tap/valve tail 90 bent pattern, swivel nut and washer
• Fits copper tube to BS EN 1057
• WRAS approved
• Solder and flux required not supplied
• Sold individually buy exactly what the job needs
• Suitable for hot and cold water and heating services

End feed means a capillary joint: clean the tube and fitting, apply flux, heat evenly and feed lead-free solder to the mouth of the fitting until a ring forms. See our guide: How to solder end feed fittings.

Also in this range: couplers, elbows and the full end feed range. Ordering for a whole job? Use the bulk fittings matrix.